Tinker, Tailor, Soldier, Sponge

View Original

Project Thor: Mjolnir Attempt 1

I have all the materials to craft Mjolnir now - to the Forge! ... or not

Materials

Mjolnir materials

So I now have all the materials for Mjolnir. Polystyrene for the hammer head, wood for the handle, leather for the handle grip and plastidip for coating the hammer head. I'm short the amount of leather needed for the loop at the bottom but I might use string or something for that.

Crafting

Initially I tried cutting the polystyrene with a craft knife but that didn't work very well. I also tried using a saw and a carving knife. These were also all terrible ideas. I finally settled on heating a bread knife over the gas hob. This cut through the polystyrene like butter but if it was too hot caused more to melt than I wanted. Sadly we end up with this:

Mjonir head 1

While the general shape is there it isn't up to my exacting (read: fairly lax) standards.

Where From Here?

I'm going to see if Fab Lab has a hot wire cutter or obtain one from somewhere else. If that fails I'll have to try the Foam Pepakura method (which I'll detail in a future post when talking about the armour).

Tom Out!

P.S. Polystyrene: http://www.ebay.co.uk/itm/290617011792

P.P.S. Wood: http://www.ebay.co.uk/itm/221116725954

P.P.P.S Leather: http://www.ebay.co.uk/itm/190699033294

P.P.P.P.S Plastidip: http://www.amazon.co.uk/gp/product/B000KL5WOI/